SA-SFPP-T10 Copper Small Form Pluggable (SFP) transceivers are based on the SFP Multi Source Agreement (MSA). They are compatible with the 10Gbase-T / 5Gbase-T / 2.5Gbase-T / 1000base-T standards as specified in IEEE Std 802.3. SA-SFPP-T10 uses the SFP's RX_LOS (must be pulled up on host) pin for link indication. If pull up or open SFP's TX_DISABLE pin, PHY IC be reset.

Product image

INTRODUCTION VIDEO

Features

Downloads

Ordering

Support

+3.3V Volt Electrical Power Interface

SA-SFPP-T10 has an input voltage range of 3.3 V +/- 5%. The 4V maximum voltage is not allowed for continuous operation.
Low-Speed Signals

MOD_DEF(1) (SCL) and MOD_DEF(2) (SDA), are open drain CMOS signals (see section VII, "Serial Communication Protocol"). Both MOD_DEF(1) and MOD_DEF(2) must be pulled up to host_Vcc
MOD_DEF(1) (SCL) and MOD_DEF(2) (SDA), are open drain CMOS signals (see section VII, "Serial Communication Protocol"). Both MOD_DEF(1) and MOD_DEF(2) must be pulled up to host_Vcc

All high-speed signals are AC-coupled internally
All high-speed signals are AC-coupled internally

Automatic crossover detection is enabled. External crossover cable is not required

links

STARVIEW SA-SFPP-T10

UAV
Drone
Solution

LEARN ABOUT Drone

STARVIEW SA-SFPP-T10

you mAY also like