SA-SFP-T1 Copper Small Form Pluggable (SFP) transceivers is high performance, cost effective module compliant with the Gigabit Ethernet and 1000- BASE-T standards as specified in IEEE 802. 3-2002 and IEEE 802.3ab, which supporting 1000Mbps data-rate up to 100 meters reach over unshielded twisted-pair CAT 5 cable. The module supports 1000 Mbps (or 10/100/1000Mbps) full duplex data-links with 5-level Pulse Amplitude Modulation (PAM) signals. All four pairs in the cable are used with symbol rate at 250Mbps on each pair.

Product image

INTRODUCTION VIDEO

Features

Downloads

Ordering

Support

Product Selection

+3.3V Volt Electrical Power Interface

The GE-GB-P has an input voltage range of 3.3 V +/- 5%. The 4 V maximum voltage is not allowed for continuous operation
Low-Speed Signals

MOD_DEF(1) (SCL) and MOD_DEF(2) (SDA), are open drain CMOS signals (see section VII, “Serial Communication Protocol”). Both MOD_DEF(1) and MOD_DEF(2) must be pulled up to host_Vcc.
High-Speed Electrical Interface

All high-speed signals are AC-coupled internally.
General Specifications

1. Clock tolerance is +/- 50 ppm 2. By default, the GE-GB-P is a full duplex device in preferred master mode 3. Automatic crossover detection is enabled. External crossover cable is not required 4. 1000 BASE-T operation requires the host system to have an SGMII interface with no clocks, and the module PHY to be configured per Application Note AN-2036. With a SERDES that does not support SGMII, the module will operate at 1000BASE-T

links

STARVIEW SA-SFP-T1

UAV
Drone
Solution

LEARN ABOUT Drone

STARVIEW SA-SFP-T1

you mAY also like